Must do the proper operation and regular maintenance work.

  1. To make the correct month clutch. When using clutch engagement to smooth, slow, faster separation. Meng Meng can not be used from close approaches to overcome the load. Can not be combined with a half away from the half-way slow down, slip slope, otherwise it will cause early wear of the clutch.

  2. To avoid dozing or unilateral bulldozing steering even when overloaded steering at full load, or unilateral bulldozing will make steering clutch slip, causing unilateral wear. Do not sharp turns, do not overload the job, otherwise it would be tracked skid and cause abnormal wear.

  3. Do not speed operation. High-speed operation will produce severe turbulence. Walk part so mechanical collision cause damage.

  4. Try to take the rough roads. Even if the road is not smooth the path of two cases have good visual crawler, so try to level the bulldozer Rose exercise, reducing bumps and shocks, thereby reducing mechanical damage to the walking part.

  5. regular checks and maintenance.

  (1) Because the job is often the forward and back, easy to make the center a large bevel gear transmission shaking off the bolt analysis, and therefore often to check and tighten the gear meshing.

  (2) Check the tightness on both sides of the crawler, timely adjustment nut tightness that bilateral agreement crawler tightness.

  (3) Check the travel section of each unit nut is loose. Symmetrical pieces can walk part of the change sides use.

  (4) Check the guide wheel, supporting Taiwan wheel seal is leaking and timely repair.